Hi Kevin,
I am pretty sure you are correct but i think it is hidden in the dealer only section that requires a login name and password. The manual for the series two programming software ( Win ) is available in several places on the Web as a pdf but to my knowledge the series one version ( Dos ) manual does not exist in free space. I am more than happy to be proved wrong if someone would like to oblige me with a location. :) Cheers, --- In [email protected], "Gmail - Kevin, Natalia, Stacey & Rochelle" <spar...@...> wrote: > > Hi Guys, > > The manuals including the service manual (from memory) and the software is > available from the Taits NZ web site if you need it. > > Kevin, ZL1KFM. > > ----- Original Message ----- > From: Chris > To: [email protected] > Sent: Monday, May 10, 2010 11:58 AM > Subject: Re: Re:[Repeater-Builder] Tait T800 manual and software > > > > > Hi larry, > > Would be interested in both if that is O.K.with you, > > I live in Aus but would gladly pay what ever you would like for them plus > postage of course. > > Could you tell me what the T800 manual covers, as there are several > different versions for either receivers, transmiters etc. > > looking forward to hearing from you, > > Chris S. > ----- Original Message ----- > From: Larry > To: [email protected] > Sent: Saturday, May 08, 2010 11:41 PM > Subject: Re:[Repeater-Builder] Tait T800 manual and software > > > > Is there anyone on the list that would like an original Tait T800 manual > with the PGM800 software? (on 5-1/4 floppy) > > I have one and just about to send it on it's way to the local incinerator. > > I might be able to transfer software off to 3.5 floppy if someone needs > it. > > Email if interested otherwise it's a goner. > > Larry - N7FM > > tait700 wrote: > > Hi, > > > > Was wondering if anyone had any knowledge or experience of any bugs > when burning a new Eprom for one of the above units ? > > > > I can compose the new .Bin file correctly using PGM800 Win ( i think ) > and send it to the Eprom burner that is telling me when it is finished that > it is copied correctly to the chip ( via Verify ) but when the chip is > installed on the eprom board and fitted to the tx module i have no VCO lock = > no transmit. > > > > I have tried adjusting the VCO trimmer but cannot get it to lock with > the new chip installed. I have added one other frequency to the original one > that was on the original chip ( up exactly 10 mhz ) but it will not lock with > either the original Channel freq or the new one on the new chip. > > > > The original Chip worked fine with the one that was on there and > comparing the .bin file from this and the new one both look the same when > opened with PGM800. > > > > I have read the previous posts on this board about creating a new eprom > but if i have done something wrong i cannot see what it is. > > > > Any info or advice would be much appreciated, > > > > Unit in question is a T881 850 - 930 mhz > > > > Regards, > > > > > > >
