Yes that is the Intuitive board I looked at. I emailed about it but it requires that the automation system wait for an acknowledgement from the board before sending the next character. However it requires two characters before it can make a tone grrrr. It doesn't take the while string in one swoop.
On 18/03/2013, at 15:12, VE4PER/ Andy <[email protected]> wrote: > something like this > > http://www.icircuits.com/prod_dtmfenc232.html > > > On 18/03/13 01:48, Gavin Stephens wrote: >> Does anyone have any ideas for something that can do this in RD... >> >> I've looked at inituitive circuits boards but they have acknowledgements >> between characters sent so no go. I've also looked at circuitwerkes genr8 >> but it requires minimum 30ms delay between sending characters etc.... Does >> anyone know of anything that will take an rs232 serial out string all at >> once from RD and turn this in dtmf without character delays or >> acknowledgement waits etc...? I'd rather use DTMF than sub-audible tones >> over an AAC independent stereo stream (left mono programme/right DTMF). >> >> >> >> _______________________________________________ >> Rivendell-dev mailing list >> [email protected] >> http://lists.rivendellaudio.org/mailman/listinfo/rivendell-dev > > _______________________________________________ > Rivendell-dev mailing list > [email protected] > http://lists.rivendellaudio.org/mailman/listinfo/rivendell-dev _______________________________________________ Rivendell-dev mailing list [email protected] http://lists.rivendellaudio.org/mailman/listinfo/rivendell-dev
