Ed, Is there any indication of continuity (solder maybe) between the top and bottom of the printed circuit board throwbar? If you have that on both ends, there's your continuity.
Darrell S --- In [email protected], "Ed Kozlowsky" <[EMAIL PROTECTED]> wrote: > > OK Gentlemen, here's a puzzle for you. Look at the turnout in the > kozlowsky folder in the photos section at this address > http://tinyurl.com/2fmqfd > > I've completely isolated this turnout by cutting all wires and gapping > the rails. As you can see, at the frog end I've segregated the points > by cutting the rails to the frog. At the point end I've stripped all > the copper off of the tie bar. The stock rails are dead. If I use an > ohm meter to check continuity, the two point rails are shorted. I can > slightly bend the points downward so they make no contact with the > stock rails...the points are still shorted. > > Can anyone offer a suggestion before I rip out this turnout and trash > it. I'm really stumped on this one. > > Ed Kozlowsky > Sanford, Maine > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/S-Scale/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/S-Scale/join (Yahoo! ID required) <*> To change settings via email: mailto:[EMAIL PROTECTED] mailto:[EMAIL PROTECTED] <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
