Hello All,
The solution for my issue was both the H323 trunk and Gatekeeper controlled
trunk should have the significant digits as 4 for the inbound calls.
And the Gatekeeper controlled trunk should have Enable Inbound Faststart.
Thanks Ryan for the hint, the only change I did was on the
Missed to mention, this issue was faced only when I originate a call from SIP
Phone registeredto CME towards SCCP/SIP Phones registered to UCM. If I
originate a call from SCCP Phone registered to CME towards SCCP/SIP Phones
registered to UCM everything is working fine without Enabling Inbound
Hi,
Voice Mail During SRST Fallback
the* vm-integration* *pattern *commands send the appropriate DTMF digits
along with the CGN, CDN, and FDN strings to reach
the correct mailbox for extension and trunk calling combinations.
you need to configure below command :
vm-integration
pattern direct 2
Hi Ben,
Yes. You have to add ccm-manager fallback-mgcp for the MGCP in SRST
scenario.
*Configuring MGCP Gateway Fallback and Cisco SRST ** ***
* To make outbound calls while in SRST mode on your MGCP gateway, you must
configure two fallback commands on the MGCP gateway. These two commands
allow
Hi All my Friends,
If the question is asked for configuring busy out few channels from MGCP
gateway is it just enough if we used. But if it not mentioned how many
channels we need to busy out what woul be correct. Just open a all
channels or keep busy few ??
*pri-group timeslots [1]-[X] service
Jason said it all,
I would say make sure the Dn you're using to create the trigger is
available in the CM.
Regards
Gurpreet
On Tue, Feb 5, 2013 at 4:47 PM, Jason Aarons scubajas...@gmail.com wrote:
Check your CCM replication, and verify no un-asigned DNs.
** **
Reset your jtapi