Dear OMs and Yls,
I just took delivery of a KX1 purchased used. I am most impressed with
the small radio and have now made four QSOs with fellow EUs running 4 Watts
to a 4 el SteppIR at 24M. Well the test will come when I change over to a
hank of wire operated against a counterpoise. The
Good morning, Doug. You can not use the KX3PD paddle directly with the
KX1 because the KX3PD is a two point mount and uses a very
different plug and jack arrangement, whereas, the KX1PD is a single
point mount and the plug is an integral 1/8 inch stereo.
If you wanted to use the KX3PD with
I found the KX1 paddle to be, at best, an acquired skill. One that I
chose not to acquire. I used the frame to homebrew a tiny touch paddle,
but that was just for fun. It worked very nicely,but required a button
battery that I didn't want to have to depend on when camping. I settled
on the
-Original Message-
From: elecraft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] On Behalf Of EricJ
Sent: 07 September 2013 18:58
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] [KX1] paddle question
I found the KX1 paddle to be, at best, an acquired skill. One that I
To: 'EricJ'; elecraft@mailman.qth.net
Subject: Re: [Elecraft] [KX1] paddle question
Hi Eric,
I thought of the palm mini but like the idea of a paddle attached to the
KX1/KX3. We agree the KX1 paddle sucks. Sorry Elecraft, I have an awful
lot that is good to say about you but your KXPD1
: elecraft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Doug Turnbull
Sent: Saturday, September 07, 2013 1:10 PM
To: 'EricJ'; elecraft@mailman.qth.net
Subject: Re: [Elecraft] [KX1] paddle question
Hi Eric,
I thought of the palm mini but like the idea
the
KXPD1. 73 Doug EI2CN and thank you again.
-Original Message-
From: Donald Butler [mailto:n...@comcast.net]
Sent: 07 September 2013 20:01
To: 'Doug Turnbull'; 'EricJ'; elecraft@mailman.qth.net
Subject: RE: [Elecraft] [KX1] paddle question
I think we often become much too critical
Can anyone tell me what size nut will properly fit the little screw that
secures the paddle to the KX1?
I'm working on a project to fabricate a stand-alone mount for the KX1
paddle. I know a 4-40 machine screw fits nicely through the bottom hole
and also could be used through the top
Stan,
Since you could not find a match, I would be suspicious of your hardware
store's stock.
It is 6-32 threads - I just threaded a 6-32 nut onto one of the thumbscrews.
73,
Don W3FPR
On 11/7/2010 7:41 PM, stan levandowski wrote:
Can anyone tell me what size nut will properly fit the
Don, thanks! 6-32 did fit but with a little wobble. I just went
downstairs and ran a known 6-32 nut up a known 6-32 stud and it also
wobbled a bit!
So 6-32 it is after all! Funny how one can fail to notice the obvious
for so long...
Guess I've spent too much time messing around with
10 matches
Mail list logo