norsat.com
>Norsat's Microwave Products Division has now achieved ISO 9001:2000
>certification
>
>
>
>> -Original Message-
>> From: Scott Ellis [mailto:[EMAIL PROTECTED]]
>> Sent: Wednesday, September 11, 2002 5:33 PM
>> To: Protel EDA Forum
>> Su
rum
> Subject: Re: [PEDA] Overlapping Polygons in 99SE
>
>
> Yes all your comments were very obvious. I will try and be a
> little clearer.
>
> Using a single layer board for simplicity - place a polygon
> and connect to
> GND. Place another polygon which overlaps the
Fax 02 49636058
- Original Message -
From: "Dwight Harm" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Thursday, September 12, 2002 1:58 PM
Subject: Re: [PEDA] Overlapping Polygons in 99SE
> You can use "Tools | Conv
You can use "Tools | Convert | Explode Polygon to free Primitives" to
accomplish that.
-Original Message-
From: Scott Ellis [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, September 11, 2002 5:33 PM
My next approach is to edit the text version of the PCB file, grab all the
track primitives t
I haven't done a lot of boards, but why would you have overlapping polygons?
There are cases where Protel will (must?) repour all the polygons -- what
order should it use then? (And will some other designer looking at this be
able to figure it out?)
-Original Message-
From: Scott Ellis [m
tralia
Ph 0412 988408 Fax 02 49636058
- Original Message -
From: <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Wednesday, September 11, 2002 9:53 PM
Subject: Re: [PEDA] Overlapping Polygons in 99SE
> In a message dated 9/11/2002 7:29:10 AM Eas
-Original Message-
From: Scott Ellis [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, 11 September 2002 11:28 p.m.
To: Protel EDA Forum
Subject: [PEDA] Overlapping Polygons in 99SE
I have a number of polygons on a board. If they overlap the second one
poured ignores the fact that the first one is there. Is
[EMAIL PROTECTED] writes:
> I have a number of polygons on a board. If they overlap the second one
> poured ignores the fact that the first one is there. Is this just a
bug? If
> so is there a way to make Protel do what is expected (i.e. not connect
> different polygons together!)
> Or am I ju
Protel EDA Forum
> Subject: [PEDA] Overlapping Polygons in 99SE
>
>
> I have a number of polygons on a board. If they overlap the
> second one poured ignores the fact that the first one is
> there. Is this just a bug? If so is there a way to make
> Protel do what i
11 matches
Mail list logo