distribution.
In short place a fab note allowing for thieving
Mike Reagan
EDSI
Frederick MD
- Original Message -
From: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Friday, April 06, 2001 8:52 AM
Subject: [PEDA] Solder Paste
I've got a question for the group.
I need to place
Place an object the size of the pad on the bottom solder
mask layer, or use a normal pad as the thieving pad with
its normal solder mask expansion rules.
Darren
I've got a question for the group.
I need to place thieving pads on some bottom side pads.
My question is how do I remove the
I've got a question for the group.
I need to place thieving pads on some bottom side pads.
My question is how do I remove the solder paste from these pads?
Thanks.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave
-
From: [EMAIL PROTECTED] [EMAIL PROTECTED]
To: [EMAIL PROTECTED] [EMAIL PROTECTED]
Date: vrijdag 6 april 2001 16:54
Subject: [PEDA] Solder Paste
I've got a question for the group.
I need to place thieving pads on some bottom side pads.
My question is how do I remove the solder paste from
On 04:00 PM 6/04/2001 +0200, Ben Uytenhaak said:
Hello,
I think this is the solution to your problem:
1) place the pad
2) double click on the pad
3) check the Past Mask Override checkbox
4) enter value higher than half the pads x- and/or y-size
5) click ok
If I'm not correct please somebody else
-Original Message-
From: Ian Wilson [EMAIL PROTECTED]
To: Protel EDA Forum [EMAIL PROTECTED]
Date: zaterdag 7 april 2001 03:13
Subject: Re: [PEDA] Solder Paste
On 04:00 PM 6/04/2001 +0200, Ben Uytenhaak said:
Hello,
I think this is the solution to your problem:
1) place the pad
2) double
Hello Ian,
stupid me. I get your point. Of course you are right. Sorry for not
thinking twice.
Regards,
Gisbert Auge
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
*