Hi All I'm in a bit of dodoo I was given a club to re-shaft by the owner of my local golf club. He picked up a really awful Big Red look alike as his friend has just got one and thinks it's great The guy is an ex hockey pro and I have to build him drivers with extra stiff shafts and arthritic grips with as many layers of build up tape as I can get to fit!! Any way I would n't normally touch this crap but as a favour i said i would do it .
I Couldn't pull the head off as I was worried about over heating in case the RED finish was as bad as the rest so i cut the shaft off and drilled out the Hosel Goodness knows what the hosel is made of but to cut a long and painful story short I I finished up with a hosel bored on the e skew To correct this I have had to slightly over bore the hosel What can i use to shim 180 degrees to make the shaft sit right. Also As this Guy wants The shaft as stiff as I can make it; what is the effect of trimming a TT D. Gold x100 all from the tip? Regards Jeremy
