George re vive clamp what a great idea I have had some trouble with the rubber jaws themselves pulling out of the clamp. who makes the prometal vice clamp is it some thing I can get from home depot here in Canada?
jeremy ingle GEORGE HUSON wrote: > Pat, > On bore-thru I add an additional clamp behind RK's > puller, I use the Pro Metal Vice Clamp from GS #8288 > with a wide body screw clamp that I made. I found that > by adding twice the clamp surface, you can pull almost > any standard head with very little heat, and the > bore-thru's with about the same heat that you need for > a standard head with one clamp. I use a mini butane, > heat the head, add a little tension, wait 1 minute, > reheat and pull the head, Hope this helps. > > George Huson > ByGeorge Custom Clubs > > --- [EMAIL PROTECTED] wrote: > > $10 to pull and save the shaft? I just finished > > pulling the head and I have to tell you that ranks > > up there with the 975's as one of the most difficult > > heads to pull. I am still having problems with the > > shaft slipping through the rubber clamp on Kennedy's > > puller. I guess I just don't have enough confidence > > to apply the pressure needed without the fear of > > smashing the shaft. $110 sounds reasonable enough. > > Thanks for your quick responses. > > Pat McGoldrick--On Target Golf > > [EMAIL PROTECTED] > > > > --- Original Message ----- > > From: [EMAIL PROTECTED] > > To: [EMAIL PROTECTED] > > Sent: Wednesday, September 24, 2003 8:55 PM > > Subject: Re: ShopTalk: FUJIKURA RESHAFT > > > > > > In a message dated 9/24/03 4:03:03 PM Pacific > > Daylight Time, [EMAIL PROTECTED] writes: > > > > > > > > > > I have a customer that wants his GBB II > > reshafted with a Vista Pro 60 shaft, could someone > > give me some kind of indication of the going rate > > for a reshaft with this shaft? This will be my first > > reshaft of the GBB II and my first experience with > > any Fujikura shaft. TIA > > Pat McGoldrick--On Target Golf > > [EMAIL PROTECTED] > > > > > > > > Hi Pat, > > I charge $10.00 for the pull, $70.00 for the > > shaft, $19.00 on the build including spineing and > > flowing, and $10.00 on the bore thru, so that's > > $109.00, if they just want it stuck with the logo up > > or down without spineing and flowing the build is > > $9.00 instead of $19.00. > > David > >
