Re: ShopTalk: ferrule creep

Sat, 04 Jun 2005 19:23:53 -0700

In a message dated 6/4/05 9:51:25 P.M. Eastern Daylight Time, [EMAIL PROTECTED] writes:
based on my experience would be ?? 20:1 ??  Maybe more.

I'd lean toward 100:1 in favor of ferrule creep!
When you see the gap first investigate creep.
That exposes the shaft/hosel joint where you can investigate a bent shaft (possibly start of a break in graphite shafts).
Observe the epoxy cone as mentioned .
LAST pull the head, clean and prep head and shaft tip (looking at condition again) and rebuild.
This is the sequence unless you just got a new shaft puller, torch, heat gun that you feel compelled to use now!

Reply via email to