I find the D2 to be one of the easiest of the Titleist bore throughs from which to remove the shaft. I've done quite a few of them using Golfsmith's heating rod technique...
1. Drill out tip plug 2. Place club in shaft puller 3. Heat about 2" to 3" of heating rod tip to cherry red 4. Insert heating rod in tip 5. Apply heat to hosel and heel area with butane micro torch for about 30-seconds 6. Attempt to pull shaft 7. If shaft doesn't pull, repeat steps 3 to 6 I've found that shafts originally installed by Titleist usually pull with one or two sequences. Reshafts usually take more sequences depending on the type of epoxy used. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Tom Janson Sent: Monday, October 06, 2008 10:31 PM To: [email protected] Subject: ShopTalk: reshaft of Titleist 907 D2 Hosel looks like it is a separate piece than the head. Is there anything special I need to do to remove this shaft? Thanks, Tom Janson -- Shoptalk ** Sponsored by the new Aldila Voodoo. Learn more at http://aldilavoodoo.com/ -- Shoptalk ** Sponsored by the new Aldila Voodoo. Learn more at http://aldilavoodoo.com/
