Use a heat gun and standard shaft pulling techniques. I had no problems
with mine. The heat gun provides more uniform, gradual heating of the
hosel/head and the shaft pulled easily. The other possibility (if you're
going to go with a 35-mm insertion depth) is to cut off the old shaft flush
with the top of the hosel and drill the old shaft out to your insertion
depth, leaving the old shaft in the bore through as a plug.
Alan Brooks
At 07:30 PM 10/6/2008 -0700, you wrote:
Hosel looks like it is a separate piece than the head. Is there anything
special I need to do to remove this shaft? Thanks, Tom Janson
--
Shoptalk ** Sponsored by the new Aldila Voodoo.
Learn more at http://aldilavoodoo.com/
--
Shoptalk ** Sponsored by the new Aldila Voodoo.
Learn more at http://aldilavoodoo.com/
