One between cheek and gum, one between tongue and gum to do one jaw line.
What specific *Where* do you want current and ions to go?
Opposite sides of "that"..whatever that is.
It's not going to make very much voltage, so distance is a big factor.
and the lower you can get it, the more will be going *through* [deep]
vs jumping over the top
Ode
At 07:11 AM 2/24/2009 -0600, you wrote:
Ode, do you mean one silver wire on the outside of the teeth, between the
teeth and cheek (below the tooth line) and the aluminum foil on the other
side of the mouth--same position--or the other side of the same row of
teeth--between the teeth and the tongue? One will pull the silver across
the whole mouth (in theory) and the other would just be pulling across one
row of teeth.
Samala,
Renee
-------Original Message-------
Lay a length of silver wire along the gum line down low so as not to
actually contact the teeth, and roll up some Aluminum foil into a "wire"
and lay it likewise along the gum line on the other side.
No virus found in this incoming message.
Checked by AVG.
Version: 7.5.557 / Virus Database: 270.11.3/1969 - Release Date: 2/24/2009
--
No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.557 / Virus Database: 270.11.3/1969 - Release Date: 2/24/2009
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
