Very enlightening, but would any of this apply to 'wall warts', which
never have a 3rd prong?  --Russ

On Tue, 21 Nov 2000 17:40:55 -0500 Marshall Dudley <[email protected]>
writes:
> russ e rosser wrote:
> 
> > Doesn't a GFI just have an internal breaker that's set at a usable 
> amp
> > rating for appliances?
> 
> No, a GFI breaker is a "ground fault interrupter."  It senses if 
> current is
> going to ground instead of back the other wire, and breaks th 
> circuit
> immediately if so.  I am not sure where they normally break, I 
> thought it was
> about 5 mA, but this site claims they cut out at 2 mA.
> http://www.suttondesigns.com/glossary/gfci.shtml
> 
> > If so, it would be triggered by the buildup of
> > *heat* which requires precious milliseconds, if not seconds.
> 
> These devices are not sensitive to heat and do not use heat like a 
> normal
> breaker.  They work in about 1/50 second although
> http://www.misterfixit.com/gfi.htm claims they operate in about 10 
> msec.
> 
> > If the
> > wands were in series with the short, I'm afraid *the body* might 
> supply
> > enough resistance (up to 1 Meg ohm, initially) to delay the 
> breaker
> > response.
> 
> 120 VAC and 1 megohm gives .12 mA.  That is not enough current to 
> make it cut
> out, a fuse blow, or to even feel.
> 
> > The bottom line, of course, is to stop current flow >5mA
> > through the wands.
> 
> 2 mA is less than 5 mA, if that is a correct figure.
> 
> >  Amid any uncertainty as to freak circuits that might
> > *possibly* arise, a fuse in-line with a wand would *definitely* 
> eliminate
> > ANY conceivable shock above its rating.  Cheap, too, BTW.
> 
> I disagree.  How fast is the fuse, usually they can take seconds to 
> melt when
> near their rating.  Also they don't even approach their rating until 
> you are
> far above the 5 mA you indicate you want to guard against.
> 
> Marshall
> 
> see http://www.addisselectric.com/gfcipage.htm also.
> 
> 
> --
> The silver-list is a moderated forum for discussion of colloidal 
> silver.
> 
> To join or quit silver-list or silver-digest send an e-mail message 
> to: 
> [email protected]  -or-  
> [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
> 
> To post, address your message to: [email protected]
> Silver-list archive: 
> http://escribe.com/health/thesilverlist/index.html
> List maintainer: Mike Devour <[email protected]>
>