"Dean T. Miller" wrote:

> Hi Marshall,
>
> On Wed, 22 Nov 2000 00:24:00 -0500, Marshall Dudley
> <[email protected]> wrote:
>
> >> [email protected]> wrote:
> >>
> >> Very enlightening, but would any of this apply to 'wall warts', which
> >> never have a 3rd prong?  --Russ
> >
> >Absolutely, that is what is so beautiful about them.  They use a transformer
> >to monitor the current in each half of the circuit, and buck the two
> >currents.  The difference current is pulled off with a 3rd winding, and goes
> >to an electronic circuit that triggers when the imbalance is more than some
> >amount, 2 to 5 mA or so.
>
> Are you sure?  I'm going to have to test some.  The GFI's 20 years ago
> didn't seem to do that (that's the last time I tested them).
>
> >See http://www.misterfixit.com/gfi.htm for more information:
>
> Two coils, huh?  I thought it was 2 resistors in a bridge.  :)
>
> However, I don't think a GFI would solve the problem described for
> wall-warts.  If, somehow (and don't ask me how), a wall-wart put out
> 120 v on the hot terminal and 0 volts on the other, the GFI should
> measure the same current through both sides of it's sensor -- unless
> you happened to touch a grounded object (or are standing in a puddle).

I suppose it could be done with a bridge, but then the resistors would have to 
be
matched very well, ie. 5 mA vs 20 amps is 400:1 ratio, or .25%.  Winding a
transformer with equal turns on both the primary and secondary is easier I
believe.  I read about them decades ago, and really have not revisited them 
until
recently.

In that case it would not help.  But how would that happen?  It would require,
not one short between the primary and secondary, but two.  And since the
secondary of the transformer of a wall wart is typically only a few ohms, the
huge surge in current would be expected to blow a fuse or throw a breaker, and 
if
not, the huge amount of power being dissapated would quickly burn the unit up.
In this case you can ignore the inductive component since the situation would
create shorted turns which would eliminate all but the leakage inductance.

Marshall


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>