That's probably a bit slow for commercial production which is why most commercial CS is HVAC or chemical precipitate or plain old runaway no control yellow brown LVDC crud.
There are some generator makers that target resellers of CS...$300 to $3000. Do a lot of research before investing.
Using huge electrodes could speed things up.
Ken
At 08:21 AM 9/13/02 -0500, you wrote:
>>>>
Marshall,<<<<
I'm getting the picture, but how slow is the LVDC?
----- Original Message -----
From: <mailto:[email protected]>Ode Coyote
To: <mailto:[email protected]>[email protected]
Sent: Thursday, September 12, 2002 8:38 AM
Subject: Re: CS>New CS generater
They're all a little or a lot different depending on the setup and specs, but both processes can make a similar product. I think it's possible to make a higher colloid to ion ratio with HVAC "if" it's set up for that.
LVDC is cheap, safe and slow. A good constant current unit can equal a good HVAC setup, much cheaper, only a lot slower.
HVAC is very expensive, fast and can be deadly to operate.
If it's not set up right, HVAC can make silver nitrates or emulsified sludge layers very very fast.
If it is set up right, HVAC can do a very fine job.
Ken
At 10:54 AM 9/12/02 -0500, you wrote:
>>>>
Marshall,<<<<
O.K., Now that I understand that much, what makes one or the other better or worse in out final product>
Thanks for taking the time to answer.
Barbara
----- Original Message -----
From: <mailto:[email protected]>Marshall Dudley
To: <mailto:[email protected]>[email protected]
Sent: Wednesday, September 11, 2002 6:43 PM
Subject: Re: CS>New CS generater
LVDC is low voltage direct current. Normally the voltage is between 9 and 30 volts, and the voltage does not change polarity, or if it does, it does so at no faster than a couple of times a minute.
HVAC is high voltage alternating current. Nominally usually around 10,000 volts, and 60 hertz frequecy.
Marshall
Barbara Liles wrote:
I haven't been on this long, but need to know the difference between LVDC and HVAC. I think that is what I keep reading. I anyone responds, could you keep it simple. I don't understand electricity not charging very well! Thanks
----- Original Message -----
From: <mailto:[email protected]>Jack Dayton
To: <mailto:[email protected]>[email protected]
Sent: Wednesday, September 11, 2002 5:21 PM
Subject: Re: CS>New CS generater
From: "mary lee gladieux" <<mailto:[email protected]>[email protected]>************************************
Subject: CS>New CS generater
Resent-Date: Wed, 11 Sep 2002 11:14:58 -0700
I'm a newbie to this board with this problem: with my brand new colloid master 777, I tried to generate one quart of approx 10 ppm CS but after 23 hours the process never completed so I shut the processor off. I attempted this on the 9th and 10th of this month. Is this huge amount of time normal to make CS? Did anyone else experience this on those dates? Thank you for any response.
Hi Mary Lee,
I'm not familiar with that generator, but
that time is WAAAAY to long.
On my LV/DC I do 42ozs of distilled water
plus a spike of 2 oz from my last batch just
to get things started. It is usually finished
in one and one half hours.
23 hours ?, something is not right. First
reread the instructions carefully, because
that time is WRONG!
Jack
-- The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour
