HAHAHA no I call it a tower but it is on someone's property. The ants are
mounted on his gazebo up high and facing into the valley this property is
about 300-500 ft above the valley where we service..

I just have to drive up there and swap it out. I never really noticed what
the D-link was setting itself too once we hooked it up we just figured it
was working lights were flashing etc DUMB DUMB DUMB!

We had a linksys up there originally but figured it was bad or something but
turned out we were having heating problems here at the noc we had the radio
up in the attic and it was cooking itself (ap-1000) before we switched out
to the canopy stuff for BH..


----- Original Message ----- 
From: "Mark Radabaugh" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Saturday, September 27, 2003 1:05 PM
Subject: Re: [smartBridges] Slow down problems



----- Original Message ----- 
From: "Blazen Wireless" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Saturday, September 27, 2003 3:47 PM
Subject: Re: [smartBridges] Slow down problems


> Okay I see you have it set like me canopy (SM) for BH to the switch then
> from the switch there are two other APPO's hooked up.
>
> What I did notice here with my replacement APPO (Thanks Kevin Ecom) is
that
> when I hook the APPO direct to a linksys switch it comes up at 10 megs
FULL
> DUPLEX!!!
>
> I wonder if the Dlink up at the tower is doing the same thing but would
that
> not show collisions in the APPO's that were already up there??
>
> And why would the Linksys show it as 10 full? instead of half duplex is
this
> a problem with the linksys or is this an issue with the APPO / ABO's???
>

I would expect if one end is Full and the other Half (AFAIK APPO's will not
do full duplex) I would expect really crappy performance.   Why a Linksys or
DLINK would see it as full is something of a mystery to me.   Dig around in
the junk pile and find an old 10Mb hub and stick it in and see if it helps.

Your not really going to tell me you have a DLINK anything 200' in the air
that you have to pay somebody to get to are you?

Mark


----------ANNOUNCEMENT----------
Don't forget to register for WISPCON IV
http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm

The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe
smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe
smartBridges)
Archives: http://archives.part-15.org


----------ANNOUNCEMENT----------
Don't forget to register for WISPCON IV
http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm

The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges 
<yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org  

Reply via email to