I concur. I have done many ethernet runs that were up to 1000 feet in length. Didn't have any issues.
-----Original Message----- From: "Don Tran" <[EMAIL PROTECTED]> Date: Mon, 30 Jul 2007 14:28:26 To:[email protected] Subject: [SOCALWUG] Re: establishing a WiFi link 200 feet should not be a problem ============================ 10Base2, which is part of the IEEE 802.3 specification, has a distance limit of 606.8 feet - 185 meters - per segment. 10 Base5, 10-Mbps baseband Ethernet ... Network managers understand the 100 meter distance limitation of 10BASE-T and 100BASE-T Ethernet and make allowances for working within these limitations On 7/30/07, Mike Burgess <[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> > wrote: --- Jeffrey Kutz <[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> > wrote: > I would like to establish a data link between two locations about a > quarter mile apart. At one of the locations I have to run a line about > 200 feet to an antenna location on a rooftop about 20 feet above ground. Attach your AP directly to the DISH with a coupler, and power over ethernet. Not sure how to get ethernet 200feet. Have you looked into ZigBee ? Edison will be using it to read electric meters in a couple of years http://en.wikipedia.org/wiki/Zigbee <http://en.wikipedia.org/wiki/Zigbee> --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "SOCALWUG" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/SOCALWUG SOCALWUG website: http://www.socalwug.org -~----------~----~----~----~------~----~------~--~---
