On 12/07/2011 07:33 AM, Soren Kristensen wrote: > Hi Niuck, > > Nicholas Esborn wrote: >> Hello, >> >> I am having no luck getting FreeBSD/amd64 8.2-RELEASE to boot on the >> Net6501. FreeBSD/i386 8.2-RELEASE works fine, but if possible I'd like >> to run amd64 in this machine's intended role. >> >> I've seen reports that 64-bit Linux and OpenBSD have been booted >> successfully, but not FreeBSD. Has anyone gotten this working? > > Have you updated to newest BIOS ? The dmesg looks like an old BIOS, > unless it's FreeBSD-64 that don't like something....
Soren, Thanks for your reply. This was with 1.41: comBIOS ver. 1.41 20111201 Copyright (C) 2000-2011 Soekris Engineering. Thanks, -nick > Best Regards, > > > Soren Kristensen > > CEO & Chief Engineer > Soekris Engineering, Inc. > > >> The kernel initializes as seen below, then it just stops. I've tried >> disabling ACPI, APIC, MSI, and MSIX in various combinations. The boot >> output changes a bit, particularly with regard to interrupts, but >> nothing I have tried has altered where the kernel stops. Also, I don't >> seem to be able to break into the debugger. >> >> For the following dmesg, ACPI, APIC, MSI, and MSIX are at defaults. >> >> KDB: debugger backends: ddb >> KDB: current backend: ddb >> ACPI Error: A valid RSDP was not found (20101013/tbxfroot-309) >> Copyright (c) 1992-2011 The FreeBSD Project. >> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 >> The Regents of the University of California. All rights reserved. >> FreeBSD is a registered trademark of The FreeBSD Foundation. >> FreeBSD 8.2-RELEASE-p2 #0: Thu Dec 1 16:42:39 MST 2011 >> [email protected]:/usr/obj/usr/src/sys/NET6501 amd64 >> Timecounter "i8254" frequency 1193182 Hz quality 0 >> CPU: Genuine Intel(R) CPU @ 1.60GHz (1600.01-MHz K8-class CPU) >> Origin = "GenuineIntel" Id = 0x20661 Family = 6 Model = 26 >> Stepping = 1 >> >> Features=0xbfe9fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE> >> >> >> Features2=0x40e3bd<SSE3,DTES64,MON,DS_CPL,VMX,EST,TM2,SSSE3,CX16,xTPR,PDCM,MOVBE> >> >> AMD Features=0x20100800<SYSCALL,NX,LM> >> AMD Features2=0x1<LAHF> >> TSC: P-state invariant >> real memory = 2147352576 (2047 MB) >> avail memory = 2060894208 (1965 MB) >> kbd0 at kbdmux0 >> ACPI Error: A valid RSDP was not found (20101013/tbxfroot-309) >> ACPI: Table initialisation failed: AE_NOT_FOUND >> ACPI: Try disabling either ACPI or apic support. >> pcib0:<Host to PCI bridge> pcibus 0 on motherboard >> pci0:<PCI bus> on pcib0 >> pcib1:<PCI-PCI bridge> irq 10 at device 23.0 on pci0 >> pci1:<PCI bus> on pcib1 >> pcib2:<PCI-PCI bridge> irq 10 at device 0.0 on pci1 >> pci2:<PCI bus> on pcib2 >> pci2:<unknown> at device 0.0 (no driver attached) >> pci2:<network, ethernet> at device 0.1 (no driver attached) >> pci2:<unknown> at device 0.2 (no driver attached) >> ohci0:<OHCI (generic) USB controller> mem 0xa0000b00-0xa0000bff irq 9 >> at device 2.0 on pci2 >> ohci0: Could not allocate irq >> device_attach: ohci0 attach returned 6 >> ohci1:<OHCI (generic) USB controller> mem 0xa0000c00-0xa0000cff irq 9 >> at device 2.1 on pci2 >> ohci1: Could not allocate irq >> device_attach: ohci1 attach returned 6 >> ohci2:<OHCI (generic) USB controller> mem 0xa0000d00-0xa0000dff irq 9 >> at device 2.2 on pci2 >> ohci2: Could not allocate irq >> device_attach: ohci2 attach returned 6 >> ehci0:<EHCI (generic) USB 2.0 controller> mem 0xa0000e00-0xa0000eff irq >> 9 at device 2.3 on pci2 >> ehci0: Could not allocate irq >> device_attach: ehci0 attach returned 6 >> pci2:<serial bus, USB> at device 2.4 (no driver attached) >> pci2:<base peripheral, SD host controller> at device 4.0 (no driver >> attached) >> pci2:<base peripheral, SD host controller> at device 4.1 (no driver >> attached) >> ahci0:<AHCI SATA controller> port 0x1020-0x103f mem >> 0xa0004400-0xa00047ff irq 11 at device 6.0 on pci2 >> ahci0: unable to map interrupt >> device_attach: ahci0 attach returned 6 >> ohci3:<OHCI (generic) USB controller> mem 0xa0004800-0xa00048ff irq 10 >> at device 8.0 on pci2 >> ohci3: Could not allocate irq >> device_attach: ohci3 attach returned 6 >> ohci4:<OHCI (generic) USB controller> mem 0xa0004900-0xa00049ff irq 10 >> at device 8.1 on pci2 >> ohci4: Could not allocate irq >> device_attach: ohci4 attach returned 6 >> ohci5:<OHCI (generic) USB controller> mem 0xa0004a00-0xa0004aff irq 10 >> at device 8.2 on pci2 >> ohci5: Could not allocate irq >> device_attach: ohci5 attach returned 6 >> ehci1:<EHCI (generic) USB 2.0 controller> mem 0xa0004b00-0xa0004bff irq >> 10 at device 8.3 on pci2 >> ehci1: Could not allocate irq >> device_attach: ehci1 attach returned 6 >> pci2:<unknown> at device 10.0 (no driver attached) >> pci2:<simple comms, UART> at device 10.1 (no driver attached) >> pci2:<simple comms, UART> at device 10.2 (no driver attached) >> pci2:<simple comms, UART> at device 10.3 (no driver attached) >> pci2:<simple comms, UART> at device 10.4 (no driver attached) >> pci2:<unknown> at device 12.0 (no driver attached) >> pci2:<serial bus> at device 12.1 (no driver attached) >> pci2:<serial bus> at device 12.2 (no driver attached) >> pci2:<serial bus> at device 12.3 (no driver attached) >> pci2:<unknown> at device 12.4 (no driver attached) >> pcib3:<PCI-PCI bridge> irq 11 at device 24.0 on pci0 >> pci3:<PCI bus> on pcib3 >> pcib4:<PCI-PCI bridge> at device 0.0 on pci3 >> pci4:<PCI bus> on pcib4 >> pcib5:<PCI-PCI bridge> at device 2.0 on pci4 >> pci5:<PCI bus> on pcib5 >> em0:<Intel(R) PRO/1000 Network Connection 7.1.9> port 0x2000-0x201f mem >> 0xa1000000-0xa101ffff,0xa1020000-0xa1023fff irq 9 at device 0.0 on pci5 >> em0: Using MSIX interrupts with 0 vectors >> em0: Unable to allocate bus resource: interrupt >> device_attach: em0 attach returned 6 >> pcib6:<PCI-PCI bridge> at device 3.0 on pci4 >> pci6:<PCI bus> on pcib6 >> em1:<Intel(R) PRO/1000 Network Connection 7.1.9> port 0x3000-0x301f mem >> 0xa2000000-0xa201ffff,0xa2020000-0xa2023fff irq 10 at device 0.0 on pci6 >> em1: Using MSIX interrupts with 0 vectors >> em1: Unable to allocate bus resource: interrupt >> device_attach: em1 attach returned 6 >> pcib7:<PCI-PCI bridge> at device 4.0 on pci4 >> pci7:<PCI bus> on pcib7 >> pcib8:<PCI-PCI bridge> irq 5 at device 25.0 on pci0 >> pci8:<PCI bus> on pcib8 >> pcib9:<PCI-PCI bridge> at device 0.0 on pci8 >> pci9:<PCI bus> on pcib9 >> pcib10:<PCI-PCI bridge> at device 2.0 on pci9 >> pci10:<PCI bus> on pcib10 >> em2:<Intel(R) PRO/1000 Network Connection 7.1.9> port 0x4000-0x401f mem >> 0xa3000000-0xa301ffff,0xa3020000-0xa3023fff irq 10 at device 0.0 on pci10 >> em2: Using MSIX interrupts with 0 vectors >> em2: Unable to allocate bus resource: interrupt >> device_attach: em2 attach returned 6 >> pcib11:<PCI-PCI bridge> at device 3.0 on pci9 >> pci11:<PCI bus> on pcib11 >> em3:<Intel(R) PRO/1000 Network Connection 7.1.9> port 0x5000-0x501f mem >> 0xa4000000-0xa401ffff,0xa4020000-0xa4023fff irq 11 at device 0.0 on pci11 >> em3: Using MSIX interrupts with 0 vectors >> em3: Unable to allocate bus resource: interrupt >> device_attach: em3 attach returned 6 >> pcib12:<PCI-PCI bridge> at device 4.0 on pci9 >> pci12:<PCI bus> on pcib12 >> pcib13:<PCI-PCI bridge> irq 9 at device 26.0 on pci0 >> pci13:<PCI bus> on pcib13 >> isab0:<PCI-ISA bridge> at device 31.0 on pci0 >> isa0:<ISA bus> on isab0 >> cpu0 on motherboard >> atrtc0:<AT Real Time Clock> at port 0x70 irq 8 on isa0 >> atrtc0: Warning: Couldn't map Interrupt. >> uart0:<Non-standard ns8250 class UART with FIFOs> at port 0x3f8-0x3ff >> irq 4 flags 0x10 on isa0 >> uart0: console (19200,n,8,1) >> Timecounter "TSC" frequency 1600013248 Hz quality 800 >> Timecounters tick every 1.000 msec >> >> This is where it stops. >> >> Thanks for any help, >> >> -nick >> >> >> >> >> _______________________________________________ >> Soekris-tech mailing list >> [email protected] >> http://lists.soekris.com/mailman/listinfo/soekris-tech -- [email protected] - all messages cryptographically signed
signature.asc
Description: OpenPGP digital signature
_______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
