Unfortunately not repaired. Could you check please:
1. Make a cube 2. Use the split edge with ratio control, and try to slide the slider to the left extreme, see the result on the viewport. I hope it’s just a local issue, and not worldwide… From: [email protected] [mailto:[email protected]] On Behalf Of Szabolcs Matefy Sent: Tuesday, June 19, 2012 9:15 AM To: [email protected] Subject: RE: SI2013SP1 Never mind I found it. I hope, that the split edge ratio PPG is repaired. From: [email protected] [mailto:[email protected]] On Behalf Of Szabolcs Matefy Sent: Tuesday, June 19, 2012 7:58 AM To: [email protected] Subject: RE: SI2013SP1 Hey And where is this update? I can’t see on subscription… From: [email protected] [mailto:[email protected]] On Behalf Of Eric Cosky Sent: Tuesday, June 19, 2012 4:23 AM To: [email protected] Subject: SI2013SP1 Just installed SP1, no problems so far and it’s nice to see a few pet bugs have been fixed. Thanks for the update. -Eric Cosky
