This is what I get, http://imgur.com/60YJx
The point isn’t able to get to the corner and there is the unexpected error in
the log.
CreatePrim "Cube", "MeshSurface"
ActivateEdgeSelTool
ActivateEdgeSelTool
SelectGeometryComponents "cube.edge[10]"
SplitEdge "cube.edge[10]", 50, False, True, siPersistentOperation
' ERROR : 2006-EDIT-SetValue - Unexpected failure.
SetValue "cube.polymsh.splitedgeop.ratioedge", 0.001
Trying to execute the SetValue command manually gives an overflow error.
SetValue "cube.polymsh.splitedgeop.ratioedge", 0.001
' ERROR : Overflow: 'SetValue' - [line 1]
Setting to 0.0010000001 doesn’t cause the error though, so it’s not a parser
error skipping the last digit.. odd.
I found that modifying C3DSplitEdgeOp.spdl so the ratioedgerange was clamped to
0.002 avoided the problem (0.0011 and smaller numbers didn’t work for me,
didn’t try to converge on the smallest usable value – the ui only shows 3
digits so 0.002 might be the limit).
Parameter "ratioedge"
{
GUID = {CF8F1A90-46B9-11d4-8C28-009027BC3A0E};
Name = "Ratio Edge ";
Description = "Ratio on edge where to split the
edge";
Type = VT_R8;
Caps = Persistable, Animatable;
Class = E3DPROPERTY_CLASS_TOPO;
Range = 0.002 to 99.999;
UIRange = 0.002 to 99.999;
}
Oddly I found if moving the mouse quickly, it would still show 0.001 with the
new clamping and the actual point location was nowhere near 0.001 – pic here:
http://imgur.com/EGahh
So, yeah, it’s a little buggy.
From: [email protected]
[mailto:[email protected]] On Behalf Of Szabolcs Matefy
Sent: Tuesday, June 19, 2012 12:46 AM
To: [email protected]
Subject: RE: SI2013SP1
Unfortunately not repaired. Could you check please:
1. Make a cube
2. Use the split edge with ratio control, and try to slide the slider to
the left extreme, see the result on the viewport. I hope it’s just a local
issue, and not worldwide…
From: [email protected]
[mailto:[email protected]] On Behalf Of Szabolcs Matefy
Sent: Tuesday, June 19, 2012 9:15 AM
To: [email protected]
Subject: RE: SI2013SP1
Never mind I found it. I hope, that the split edge ratio PPG is repaired.
From: [email protected]
[mailto:[email protected]] On Behalf Of Szabolcs Matefy
Sent: Tuesday, June 19, 2012 7:58 AM
To: [email protected]
Subject: RE: SI2013SP1
Hey
And where is this update? I can’t see on subscription…
From: [email protected]
[mailto:[email protected]] On Behalf Of Eric Cosky
Sent: Tuesday, June 19, 2012 4:23 AM
To: [email protected]
Subject: SI2013SP1
Just installed SP1, no problems so far and it’s nice to see a few pet bugs have
been fixed.
Thanks for the update.
-Eric Cosky
