Yes Terry I see the correct starting freq. but then the programmed freqs are off by - 1MHz.
I do not think it is soldering problem. I may think in the possibility of Tony being lead to something else on his new programmer. Could that be the problem.? I got 3 pics and all 3 are the same I put an old version pic are everything is right. So it must be the pic. Thank you very much for your input. Regards On Sun, Jun 1, 2008 at 5:24 PM, Terry <[EMAIL PROTECTED]> wrote: > --- In [email protected] <softrock40%40yahoogroups.com>, "Jose > Bonanca" <[EMAIL PROTECTED]> > wrote: > > > > Been testing this SW with a XTALL 1.1 and Xtall version 1. > > In both version the SW works but very far away from the center > frequencies. > > sometimes more than 1MHZ away. > > The PIC´s I got (3) have been programmed by Tony and he says no one > else is > > reporting the trouble. > > > > Am I alone in this thread ?? > > > > Thanks to all. > > 73 > > > > -- > > Jose Bonanca (CT1aos) > > > > Hello Jose. > Do you see the approx 56.3MHz (or other default freq), when the power > is first applied? > > I just finished building up one XTALL 1.1, and it would only > intermittently change freqs. It turns out that there was not a good > solder joint under the Si570 on one pin. After resoldering the 570, > it came up fine. > > Terry > WB4JFI > > > -- Jose Bonanca (CT1aos)
