Thanks Tony. 73 On Sun, Jun 1, 2008 at 6:43 PM, Tony Parks <[EMAIL PROTECTED]> wrote:
> Hi Jose, > > Tom's v2.4 HEX file is in the XTALL daughter board files folder. (* > XTALLV2.4.hex*<http://f1.grp.yahoofs.com/v1/kNVCSCqYI-m-H0nF0MYCY9bH8oUfwHjGv893iLFV-i7HDIQGVDJwi3yJlHQKcZwL9-hozhTVlAg-oo1_jEDRKIf5Opg7/XTALL%20daughter%20board/XTALLV2.4.hex> > * *) > > 73, > Tony KB9YIG > > ---- Original Message ----- > > *From:* Jose Bonanca <[EMAIL PROTECTED]> > *To:* [email protected] > *Sent:* Sunday, June 01, 2008 1:34 PM > *Subject:* Re: [softrock40] Re: Tom´s Software version 2.4 > > Jim, at least some one else with wrong freq,. > I am going to receive a serial pic programmer by late thist week. > > Now I need to have the file of Tom´s v.2.4 to try to reprogram the pics I > have here. > Could you please send me the file appended to my e-mail address, please... > > > [EMAIL PROTECTED] > > Thank you. > > Regards > > On Sun, Jun 1, 2008 at 6:16 PM, James R. Elledge <[EMAIL PROTECTED]> wrote: > >> --- In [email protected] <softrock40%40yahoogroups.com>, >> "Terry" <[EMAIL PROTECTED]> wrote: >> > >> > --- In [email protected] <softrock40%40yahoogroups.com>, "Jose >> Bonanca" <jbct1aos@> >> > wrote: >> > > >> > > Been testing this SW with a XTALL 1.1 and Xtall version 1. >> > > In both version the SW works but very far away from the center >> > frequencies. >> > > sometimes more than 1MHZ away. >> > > The PIC´s I got (3) have been programmed by Tony and he says no >> one >> > else is >> > > reporting the trouble. >> > > >> > > Am I alone in this thread ?? >> > > >> > > Thanks to all. >> > > 73 >> > > >> > > -- >> > > Jose Bonanca (CT1aos) >> > > >> > >> > Hello Jose. >> > Do you see the approx 56.3MHz (or other default freq), when the >> power >> > is first applied? >> > >> > I just finished building up one XTALL 1.1, and it would only >> > intermittently change freqs. It turns out that there was not a >> good >> > solder joint under the Si570 on one pin. After resoldering the >> 570, >> > it came up fine. >> > >> > Terry >> > WB4JFI >> > >> The 12F683 was the problem with mine, wrong freq's. Erased and re- >> loaded the chip - problem solved - worked perfectly then. >> >> Jim - KB2XJ >> >> > > > -- > Jose Bonanca (CT1aos) > > > -- Jose Bonanca (CT1aos)
