--- In [email protected], "Terry" <[EMAIL PROTECTED]> wrote: > > --- In [email protected], "Jose Bonanca" <jbct1aos@> > wrote: > > > > Been testing this SW with a XTALL 1.1 and Xtall version 1. > > In both version the SW works but very far away from the center > frequencies. > > sometimes more than 1MHZ away. > > The PIC´s I got (3) have been programmed by Tony and he says no one > else is > > reporting the trouble. > > > > Am I alone in this thread ?? > > > > Thanks to all. > > 73 > > > > -- > > Jose Bonanca (CT1aos) > > > > Hello Jose. > Do you see the approx 56.3MHz (or other default freq), when the power > is first applied? > > I just finished building up one XTALL 1.1, and it would only > intermittently change freqs. It turns out that there was not a good > solder joint under the Si570 on one pin. After resoldering the 570, > it came up fine. > > Terry > WB4JFI > The 12F683 was the problem with mine, wrong freq's. Erased and re- loaded the chip - problem solved - worked perfectly then.
Jim - KB2XJ
