Thank you JIM I got the file already. cheers
On Sun, Jun 1, 2008 at 6:59 PM, James R. Elledge <[EMAIL PROTECTED]> wrote: > Hi Jose > > The file Tony pointed you to is the one I used. Loaded two chips with > that HEX file and both work exactly as they are intended. Also tried > the others Tom has provided and the work perfectly. > > Hope you have the problem solved soon. > > Jim - KB2XJ > > --- In [email protected] <softrock40%40yahoogroups.com>, "Tony > Parks" <[EMAIL PROTECTED]> wrote: > > > > Hi Jose, > > > > Tom's v2.4 HEX file is in the XTALL daughter board files folder. > (XTALLV2.4.hex ) > > > > 73, > > Tony KB9YIG > > > > ---- Original Message ----- > > From: Jose Bonanca > > To: [email protected] <softrock40%40yahoogroups.com> > > Sent: Sunday, June 01, 2008 1:34 PM > > Subject: Re: [softrock40] Re: Tom´s Software version 2.4 > > > > > > > > Jim, at least some one else with wrong freq,. > > I am going to receive a serial pic programmer by late thist week. > > > > Now I need to have the file of Tom´s v.2.4 to try to reprogram > the pics I have here. > > Could you please send me the file appended to my e-mail address, > please... > > > > > > [EMAIL PROTECTED] > > > > Thank you. > > > > Regards > > > > > > On Sun, Jun 1, 2008 at 6:16 PM, James R. Elledge <[EMAIL PROTECTED]> > wrote: > > > > > > --- In [email protected] <softrock40%40yahoogroups.com>, > "Terry" <wb4jfi@> wrote: > > > > > > --- In [email protected] <softrock40%40yahoogroups.com>, > "Jose Bonanca" <jbct1aos@> > > > wrote: > > > > > > > > Been testing this SW with a XTALL 1.1 and Xtall version 1. > > > > In both version the SW works but very far away from the > center > > > frequencies. > > > > sometimes more than 1MHZ away. > > > > The PIC´s I got (3) have been programmed by Tony and he > says no > > one > > > else is > > > > reporting the trouble. > > > > > > > > Am I alone in this thread ?? > > > > > > > > Thanks to all. > > > > 73 > > > > > > > > -- > > > > Jose Bonanca (CT1aos) > > > > > > > > > > Hello Jose. > > > Do you see the approx 56.3MHz (or other default freq), when > the > > power > > > is first applied? > > > > > > I just finished building up one XTALL 1.1, and it would only > > > intermittently change freqs. It turns out that there was not > a > > good > > > solder joint under the Si570 on one pin. After resoldering > the > > 570, > > > it came up fine. > > > > > > Terry > > > WB4JFI > > > > > > > The 12F683 was the problem with mine, wrong freq's. Erased and > re- > > loaded the chip - problem solved - worked perfectly then. > > > > Jim - KB2XJ > > > > > > > > > > > > > > > > -- > > Jose Bonanca (CT1aos) > > > > > -- Jose Bonanca (CT1aos)
