Hi Jose The file Tony pointed you to is the one I used. Loaded two chips with that HEX file and both work exactly as they are intended. Also tried the others Tom has provided and the work perfectly.
Hope you have the problem solved soon. Jim - KB2XJ --- In [email protected], "Tony Parks" <[EMAIL PROTECTED]> wrote: > > Hi Jose, > > Tom's v2.4 HEX file is in the XTALL daughter board files folder. (XTALLV2.4.hex ) > > 73, > Tony KB9YIG > > ---- Original Message ----- > From: Jose Bonanca > To: [email protected] > Sent: Sunday, June 01, 2008 1:34 PM > Subject: Re: [softrock40] Re: Tom´s Software version 2.4 > > > > Jim, at least some one else with wrong freq,. > I am going to receive a serial pic programmer by late thist week. > > Now I need to have the file of Tom´s v.2.4 to try to reprogram the pics I have here. > Could you please send me the file appended to my e-mail address, please... > > > [EMAIL PROTECTED] > > Thank you. > > Regards > > > On Sun, Jun 1, 2008 at 6:16 PM, James R. Elledge <[EMAIL PROTECTED]> wrote: > > > --- In [email protected], "Terry" <wb4jfi@> wrote: > > > > --- In [email protected], "Jose Bonanca" <jbct1aos@> > > wrote: > > > > > > Been testing this SW with a XTALL 1.1 and Xtall version 1. > > > In both version the SW works but very far away from the center > > frequencies. > > > sometimes more than 1MHZ away. > > > The PIC´s I got (3) have been programmed by Tony and he says no > one > > else is > > > reporting the trouble. > > > > > > Am I alone in this thread ?? > > > > > > Thanks to all. > > > 73 > > > > > > -- > > > Jose Bonanca (CT1aos) > > > > > > > Hello Jose. > > Do you see the approx 56.3MHz (or other default freq), when the > power > > is first applied? > > > > I just finished building up one XTALL 1.1, and it would only > > intermittently change freqs. It turns out that there was not a > good > > solder joint under the Si570 on one pin. After resoldering the > 570, > > it came up fine. > > > > Terry > > WB4JFI > > > > The 12F683 was the problem with mine, wrong freq's. Erased and re- > loaded the chip - problem solved - worked perfectly then. > > Jim - KB2XJ > > > > > > > > -- > Jose Bonanca (CT1aos) >
