Did you buy that white DIY?!?!?!? And do they have the good center caps???
Craig -- In [email protected], christopher_pelley <[EMAIL PROTECTED]> wrote: > > Well I got a look at the new 2006 DIY cube. Craig is right-- these do > seem to be all-new manufacture. The corner cap gap is less than 1mm, > a little smaller than I imagined. Also the arched centers are no > longer grafted on to flat centers (look closely at the 2005 centers). > Instead it all seems to be one molded piece. Regarding the edges > catching on the centers-- I did also experience that, but only when > the caps were still off. Finally, one other difference is the > manufacturing code is absent (i.e. M1005B imprinted on one corner cap). > > BTW, the white DIY arched centers exist: > > http://tinyurl.com/84sdz > > Hope they start selling the kits again soon. > > Chris > > > --- In [email protected], "Craig Bouchard" > <logitewty@> wrote: > > > > I'll try to address everyone: > > > > Thank you all for the congratulations... > > > > To Chris: I think I've found a fault with the DIYs...The edges are > > bigger than the center pieces (you know how there is an opening on > the > > one side of the edge) well that can slide over the center, which I > > have found can cause pops, and send center caps across the room...But > > I still love it :) > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/speedsolvingrubikscube/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
