Hello Otto,
Is this monitor so ancient that it doesn't report its supported
timings through DDC? Is it possible that you're using a bad cable,
or that the cable isn't properly connected? Was the monitor
powered on when you powered on the Sun Ray?
Yes, but I use a RGB-cable (VGA-cable got lost somehow, an dthis
cable does not support DDC).
That explains why the Sun Ray will only drive the monitor at 640x480.
Yes, indeed. I replaced it with a normal VGA-cable and boom, I had the
expected 1280x1024 without further ado.
bash-3.00# /opt/SUNWut/sbin/utresadm -a -c IEEE802.0003BABBAA64 -t
default [EMAIL PROTECTED]
Internal system error
It probably means that you haven't activated the Sun Ray Data Store
on the server, so 'utresadm' has no place to store this timing
configuration. You need to run 'utconfig' to activate the Data
Store before you can use commands like 'utresadm' that want to
store group-wide settings. 'utxconfig' is just about the only
configuration command that works without the Data Store, and that's
only because it was invented before the Data Store existed.
That error message is horrible, it should say something more
helpful than "Internal system error".
Yes, after utconfig all these commands started working. Even better
that I do not need them anymore after replacing the cable. :-)
Regards,
Andreas
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
