I want to disable power off on sunray3. My current config is Solaris 10 5/08 (x86) running SRSS 4.0 127554-05 I have added sunray3+ to network but don't have luxury of updating to 4.2 yet. From what I have researched, it appears I need 4.2 (140994-02 or higher) to load firmware_gui if I want to control from the DTU. I am also assuming the reference in the release notes about the .parm file is available only with 4.2.
With my current config, do I have any options? (Here's is where I would vent about turning off power as a default) Thanks Keith Ives IT Network Engineer Staff General Dynamics C4S [email protected] <mailto:[email protected]> 379 E. Ramsey San Antonio, TX 78216 ph. 210-308-6367 This message and/or attachments may include information subject to GDC4S O.M. 1.8.6 and GD Corporate Policy 07-105 and are intended to be accessed only by authorized recipients. Use, storage and transmission are governed by General Dynamics and its policies. Contractual restrictions apply to third parties. Recipients should refer to the policies or contract to determine proper handling. Unauthorized review, use, disclosure or distribution is prohibited. If you are not an intended recipient, please contact the sender and destroy all copies of the original message
_______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
