Hi,
I just installed the snapshot from 01/24/2007, and after ~3 hours, I
made an ACL config change and applied changes. When I went to my client
PC to verify I could then connect to the host I wanted access to, I
still could not. I logged on to the pfSense box via SSH, and noticed
check_reload_status was not running. I started it by hand, and the
config was applied immediately, and I could then get access from the PC,
as I expected.
Is there anything we can do about this?
-Kyle
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
