Alexsander Loula wrote:
Hi Folks,
I have 2 WAN's (WAN1 - production and WAN2 - backup) and I need to set
them as fail over (when WAN1 goes down WAN2 takes the traffic and when
WAN1 goes up again it will takes the traffic). Both are DHCP.
I have followed this procedure in 2 machines (PC and WRAP) without
success: http://doc.pfsense.org/index.php/MultiWanVersion1.2
I did several tests changing mainly the Load Balance and Firewall
(NAT/Rules) services with no success. It's very intermittent even
doing the 3 pools that's not my case. Sometimes it works mainly when
the Load Balance status indicators are green and sometimes does not
work when the indicators are yellow.
Actually I don't want to have the load balance between WAN1 and WAN2,
only the fail over from WAN1 to WAN2.
Is someone doing it successfully?
Best Regards,
Alex
Many people are doing this successfully. If you have your WAN
interfaces load balancing, then it means you have your pool configured
for load balancing. Change the behavior to failover.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
