This is my current setup: I'm not using CARP, only the Load Balance service (pools).
2009/3/23 Robert Mortimer <[email protected]> > If you have two PF machines (One for each ADSL) you can use CARP to get the > failover you require. > > > > Otherwise failover between to WANs on the same Pf machine is covered in the > load balancing. > > > > Rob > > ----- Original Message ----- > From: "Veiko Kukk" <[email protected]> > To: [email protected] > Sent: Monday, 23 March, 2009 14:30:28 GMT +00:00 GMT Britain, Ireland, > Portugal > Subject: Re: [pfSense Support] Multi-WAN with Fail Over > > Alexsander Loula wrote: > > Hi Folks, > > > > I have 2 WAN's (WAN1 - production and WAN2 - backup) and I need to set > > them as fail over (when WAN1 goes down WAN2 takes the traffic and when > > WAN1 goes up again it will takes the traffic). Both are DHCP. > > Do you have dual router setup or are those WAN's connected to the same > machine? If you have dual router setup, then WAN failover won't work for > you. I have tested it extensively with no luck of any combination. > Single machile dual WAN failover works. > > veiko > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org > >
<<attachment: topology.gif>>
--------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
