If you have two PF machines (One for each ADSL) you can use CARP to get the
failover you require.
Otherwise failover between to WANs on the same Pf machine is covered in the
load balancing.
Rob
----- Original Message -----
From: "Veiko Kukk" <[email protected]>
To: [email protected]
Sent: Monday, 23 March, 2009 14:30:28 GMT +00:00 GMT Britain, Ireland, Portugal
Subject: Re: [pfSense Support] Multi-WAN with Fail Over
Alexsander Loula wrote:
> Hi Folks,
>
> I have 2 WAN's (WAN1 - production and WAN2 - backup) and I need to set
> them as fail over (when WAN1 goes down WAN2 takes the traffic and when
> WAN1 goes up again it will takes the traffic). Both are DHCP.
Do you have dual router setup or are those WAN's connected to the same
machine? If you have dual router setup, then WAN failover won't work for
you. I have tested it extensively with no luck of any combination.
Single machile dual WAN failover works.
veiko
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
