Alexsander Loula wrote:
Hi Folks,
I have 2 WAN's (WAN1 - production and WAN2 - backup) and I need to set
them as fail over (when WAN1 goes down WAN2 takes the traffic and when
WAN1 goes up again it will takes the traffic). Both are DHCP.
Do you have dual router setup or are those WAN's connected to the same
machine? If you have dual router setup, then WAN failover won't work for
you. I have tested it extensively with no luck of any combination.
Single machile dual WAN failover works.
veiko
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
