Search the archive for the subject: "Thunderbolt repair"
and "Thunderbolt quits".
Brian found a bad voltage on his power supply.
Perhaps your PC's power-saving feature?
Is your Microsoft Windows serial mouse feature disabled?
If it is not communicating at all, have you tried a different
baud rate?
I have a TAPR Thunderbolt that quits talking out the serial port
after a period of time. Only a power down reset gets it
responding again for a while. I haven't opened it up yet; I
bought one from fluke.L to get back on the air. The new one
works fine.
Mike - AA8K
On 04/13/2011 12:13 PM, bill wrote:
I have a problem with the data out of the thunderbolt serial
port. I was monitoring with
ko4bb monitor and the thunderbolt quit sending data.
I seem to remember some discussion of this on the list some time
ago. I did a
search but didn't find anything.
Any suggestion ? Otherwise I will reverse engineer the serial
port and trouble shoot.
Bill K7NOM
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
