Dear Said, I am having a very hard time trying to guess the communication port configuration of the HP Z3805A. I am trying with different port settings to match the PC and using different monitor and control programs. The afternoon was not that fruitful regarding this. Is there a chance you have the default port configuration for the Z3805A so I can match my PC serial port configuration?
I might be unavailable to respond to you tomorrow during the day, as I will be at Queretaro with restricted access to the Internet. Despite this I will be able to read my mail, not respond to it. Hope you don't mind. Your kind help is always welcome. Thanks. Regards, Edgardo Molina Dirección IPTEL www.iptel.net.mx T : 55 55 55202444 M : 04455 20501854 Piensa en Bits SA de CV Información anexa: CONFIDENCIALIDAD DE INFORMACION Este mensaje tiene carácter confidencial. Si usted no es el destinarario de este mensaje, le suplicamos se lo notifique al remitente mediante un correo electrónico y que borre el presente mensaje y sus anexos de su computadora sin retener una copia de los mismos. Queda estrictamente prohibido copiar este mensaje o hacer usode el para cualquier propósito o divulgar su en forma parcial o total su contenido. Gracias. NON-DISCLOSURE OF INFORMATION This email is strictly confidential and may also be privileged. If you are not the intended recipient please immediately advise the sender by replying to this e-mail and then deleting the message and its attachments from your computer without keeping a copy. It is strictly forbidden to copy it or use it for any purpose or disclose its contents to any third party. Thank you. On Oct 14, 2012, at 11:05 PM, [email protected] wrote: > Hi Edgardo, > > I think the Z3805A and 58503A are identical, except in the rubber bumpers, > maybe the power supply voltage setting, and the ID string.. > > I don't really care, the three units I have perform much better than > anything else I have, so that satisfies my requirements.. > > In fact one of the units' ADEV can only be qualified by the BVA 8600 o > scillator I have, and I don't know if I am measuring the BVA performance or > the > 58503A because I am measuring right at the specification of the BVA unit.. > Wish I had two BVA's :) > > bye, > Said > > > In a message dated 10/14/2012 15:41:25 Pacific Daylight Time, > [email protected] writes: > > Derived question: Will I get better GPSDO performance if I use a 58503A > receiver? Or do you think our units match those 58503A GPSDOs out there? > > Again, thanks to everybody who helped me to figure out about my receivers > and their inner workings. As always, you all made my day. > > > Best regards, > > > > Edgardo Molina > Dirección IPTEL > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
