On 05/11/2013 12:33 AM, Tom Knox wrote:
Thanks Magnus;
Do not go to any extra trouble on my account. The PM6690 also has a 53132A mode
that may work. I assumed all this had been tried before and I could save a lot
of time and effort
At least on my counter with my FW it didn't work with the 53132A mode.
It would be good if it could be supported natively by TimeLab.
Cheers,
Magnus
Best Wishes;
Thomas Knox
Date: Fri, 10 May 2013 22:16:54 +0200
From: [email protected]
To: [email protected]
Subject: Re: [time-nuts] TimeLab PM6690 CNT9X?
Hi Tom,
On 05/10/2013 08:02 PM, Tom Knox wrote:
Has anyone used Time Lab with The current Fluke PM6690, Spectracom CNT90/91?
Thanks;
CNT90 (aka PM6690) did not use to work with TimeLab, as CNT90 does not
to talk-only, which is the normal requirement for TimeLab generic
counter support.
I don't remember if I managed to get it operating or not, but I could
take it for a test-spin if you like. The CNT-80 driver should work
thought, as it builds on the SCPI commandset.
Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
