Hal, It depends a lot on the thermistor. As with any component, there are higher precision models that would be pretty repeatable within a model number, and cheaper ones that will be somewhat less repeatable. In this case I didn’t have a specific model number, nor specific nominal/beta values, so I chose a reasonable 100K NTC thermistor, and am adjusting for that.
Nigel > On Feb 27, 2016, at 20:21, Hal Murray <hmur...@megapathdsl.net> wrote: > > > rich...@karlquist.com said: >> If you replaced the thermistor with an exact replacement, then you shouldn't >> need to change the pot. ... > > How repeatable are thermistors? How close do you need/want to get the > temperature? > > > -- > These are my opinions. I hate spam. > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.