I do not think you understand under no circumstances will I get in to the board business.I do all the boards for an off list group 20 designs last week from China.Willing to help some one to do this board it was part of last weeks shipping Corby was first to test it so I am willing to share it because I know it works, pin location is critical, I just added an amp, still being checked but not as critical as OCXO and trim pot pins Bert In a message dated 10/26/2018 2:16:16 PM Eastern Standard Time, [email protected] writes:
Yep!! Count me in for a few also!! maybe 4 or 5... Dave M Wes wrote:> I'm not up to doing the whole project, but I would certain be> interested in 2 or 3 boards for sure.>> Wes Stewart N7WS>> On 10/26/2018 5:51 AM, Bob Martin wrote:>> Bert,>>>> That looks like a useful board. Certainly some of the oscillators>> I'm giving away would fit nicely on it. Since it looks like a two>> layer board, a quick check at pcbway.com puts the cost at $.79>> apiece at the 100 quantity exclusive of shipping.>>>> Best,>>>> Bob Martin>>>> On 10/26/2018 4:17 AM, ew via time-nuts wrote:>>>>>>>>> There recently was a request for an OCXO board. I did a layout, see>>> attached and had Corby do his usual QC test.>>>>>>>>> If some one is interested to make boards and maybe sell to other>>> time nuts please contact me off list and I will get you code and>>> possible suppliers.>>>>>> Board does not have an amp but could be added, if so, please>>> advise, what should be added. Regardless what the direct output>>> will remain>>>>>> Bert Kehren>>>> _______________________________________________time-nuts mailing list -- [email protected] unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.comand follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
