Hi Next we would need LH support for three TICC’s to do three corner hat …. :)
Maybe a module for each TICC ….. Bob > On Jan 8, 2019, at 2:37 PM, Magnus Danielson <mag...@rubidium.se> wrote: > > Hmm... and idea. > > For some GPSDOs you get a PPS and is "raw" from GPS module and not > resynthesized from the steered 10 MHz. > > Now, if one uses this PPS it would get quite a bit of noise, but if one was > to measure that noise against the smoothed 10 MHz with a separate TIC/TICC > one should be able to use the PPS as a transfer oscillator with the right > rate but get close to the smoothed 10 MHz as stability. > > So, it would be neat to be able to have two TIC/TICCs wired up, one for the > PPS/10 MHz and the other for PPS to DUT and then compensate the later > measurement with the former through subtraction. > > Sure, this can be achieved by so many other ways, but it would be fun to see > if it pans out when you have the spare TIC/TICC and is able to pull data from > several in real-time. > > Cheers, > Magnus > > On 2019-01-08 20:28, Mark Sims wrote: >> Lady Heather also supports the TICC. The TICC can be the main input >> "receiver" device and/or an auxiliary input device. With two TICCs >> connected you can process four channels of data. >> >> Heather lets you configure the main input device TICC parameters and also >> has the ability to "tune" the TICC channel offsets, etc. >> >> >> ------------- >> >>> The TICC talks to a host computer using ASCII on USB. >> John Miles' TimeLab software can read data directly from it, or you can >> just save the data as a text file with a terminal program >> _______________________________________________ >> time-nuts mailing list -- time-nuts@lists.febo.com >> To unsubscribe, go to >> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com >> and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.