I think the MIB520 has two ports, one for programming and one for data I/O. I of course forget which is which, have you tried both? Do you have any motes already programmed to send data to the PC that you can try as well?
I could be wrong about motelist. It might work in some fashion with the 520 since it is a USB device as well. Each vendor and version seems to have a different version of the program, so the Moteview one could work as you say. MS Isabelle Hang wrote: > Finally, I have reinstalled the system, but still I get the same > error. > The device manager seems to show quite normal results: Com3 and Com4 > are recognized, so the driver is installed. > Could it be a driver-problem? Has anybody an idea? > > Thank you for the information about the motelist command. It has > worked with Moteview and Micaz and so I thought, it must also work > here. > > Best regards > Isabelle > > ------------------- >> Did you move the USB cable to a different port? >> Widows seems to like to re-assign COM port numbers >> based on where they are connected. You might try >> looking in the Device Manager under "Ports" to see >> if it has any enlightening details. >> >> On the subject of Motelist. It only works with telos >> type devices. The micas don't respond to USB inquiries. >> >> MS >> >> Isabelle Hang wrote: >>> Hi all, >>> >>> I use Cygwin on Windows XP, a mib520 and a micaz mote. (I am quite >>> new, so do you need further information?) >>> It was all working fine and I was able to program the motes. >>> But suddenly I get the following error, if I try to install a > program >>> on a mote: >>> >>> >>> $make micaz install mib510./dev/ttyS2 >>> mkdir -p build/micaz >>> ..... >>> ..... >>> ..... >>> writing TOS image >>> cp build/micaz/main.srec build/micaz/main.srec.out >>> installing micaz binary using mib510 >>> uisp -dprog=mib510 -dserial=/dev/ttyS2 --wr_fuse_h=0xd9 >>> -dpart=ATmega128 --wr_fuse_e=ff --erase --upload >>> if=build/micaz/main.srec.out >>> Firmware Version: . >>> Failed to enter programming mode. >>> make: *** [program] Error 2 >>> >>> I have looked in the mailinglist, but there was no proper solution > for >>> this problem. >>> Please can you help me? I have no idea how to fix this problem. >>> >>> Best regards, >>> Isa >>> _______________________________________________ >>> Tinyos-help mailing list >>> [email protected] >>> > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-he > lp > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
