Using the first port, I get the described error, using the second port, I get the message 'Programmer is not responding'. I guess the latter is the data port. Really weird is, that the uploading sometimes works.(Perhaps one time out of fifty). I have really no idea! Have anybody a clue?
Best regards, Isabelle ------------------- > I think the MIB520 has two ports, one for programming > and one for data I/O. I of course forget which is which, > have you tried both? Do you have any motes already programmed > to send data to the PC that you can try as well? > > I could be wrong about motelist. It might work in some > fashion with the 520 since it is a USB device as well. > Each vendor and version seems to have a different version > of the program, so the Moteview one could work as you say. > > MS > > Isabelle Hang wrote: > > Finally, I have reinstalled the system, but still I get the same > > error. > > The device manager seems to show quite normal results: Com3 and Com4 > > are recognized, so the driver is installed. > > Could it be a driver-problem? Has anybody an idea? > > > > Thank you for the information about the motelist command. It has > > worked with Moteview and Micaz and so I thought, it must also work > > here. > > > > Best regards > > Isabelle > > > > ------------------- > >> Did you move the USB cable to a different port? > >> Widows seems to like to re-assign COM port numbers > >> based on where they are connected. You might try > >> looking in the Device Manager under "Ports" to see > >> if it has any enlightening details. > >> > >> On the subject of Motelist. It only works with telos > >> type devices. The micas don't respond to USB inquiries. > >> > >> MS > >> > >> Isabelle Hang wrote: > >>> Hi all, > >>> > >>> I use Cygwin on Windows XP, a mib520 and a micaz mote. (I am quite > >>> new, so do you need further information?) > >>> It was all working fine and I was able to program the motes. > >>> But suddenly I get the following error, if I try to install a > > program > >>> on a mote: > >>> > >>> > >>> $make micaz install mib510./dev/ttyS2 > >>> mkdir -p build/micaz > >>> ..... > >>> ..... > >>> ..... > >>> writing TOS image > >>> cp build/micaz/main.srec build/micaz/main.srec.out > >>> installing micaz binary using mib510 > >>> uisp -dprog=mib510 -dserial=/dev/ttyS2 --wr_fuse_h=0xd9 > >>> -dpart=ATmega128 --wr_fuse_e=ff --erase --upload > >>> if=build/micaz/main.srec.out > >>> Firmware Version: . > >>> Failed to enter programming mode. > >>> make: *** [program] Error 2 > >>> > >>> I have looked in the mailinglist, but there was no proper solution > > for > >>> this problem. > >>> Please can you help me? I have no idea how to fix this problem. > >>> > >>> Best regards, > >>> Isa > >>> _______________________________________________ > >>> Tinyos-help mailing list > >>> [email protected] > >>> > > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-he > > lp > > _______________________________________________ > > Tinyos-help mailing list > > [email protected] > > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-he lp > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
