Yes, I went and looked. The low port # is the programmer, high # is for MOTECOM. Perhaps you can try your programmer on a different host machine? Or different USB jack/hub/etc?
MS Isabelle Hang wrote: > Using the first port, I get the described error, using the second > port, I get the message 'Programmer is not responding'. > I guess the latter is the data port. > Really weird is, that the uploading sometimes works.(Perhaps one time > out of fifty). > I have really no idea! Have anybody a clue? > > Best regards, > Isabelle > ------------------- >> I think the MIB520 has two ports, one for programming >> and one for data I/O. I of course forget which is which, >> have you tried both? Do you have any motes already programmed >> to send data to the PC that you can try as well? >> >> I could be wrong about motelist. It might work in some >> fashion with the 520 since it is a USB device as well. >> Each vendor and version seems to have a different version >> of the program, so the Moteview one could work as you say. >> >> MS >> >> Isabelle Hang wrote: >>> Finally, I have reinstalled the system, but still I get the same >>> error. >>> The device manager seems to show quite normal results: Com3 and > Com4 >>> are recognized, so the driver is installed. >>> Could it be a driver-problem? Has anybody an idea? >>> >>> Thank you for the information about the motelist command. It has >>> worked with Moteview and Micaz and so I thought, it must also work >>> here. >>> >>> Best regards >>> Isabelle >>> >>> ------------------- >>>> Did you move the USB cable to a different port? >>>> Widows seems to like to re-assign COM port numbers >>>> based on where they are connected. You might try >>>> looking in the Device Manager under "Ports" to see >>>> if it has any enlightening details. >>>> >>>> On the subject of Motelist. It only works with telos >>>> type devices. The micas don't respond to USB inquiries. >>>> >>>> MS >>>> >>>> Isabelle Hang wrote: >>>>> Hi all, >>>>> >>>>> I use Cygwin on Windows XP, a mib520 and a micaz mote. (I am > quite >>>>> new, so do you need further information?) >>>>> It was all working fine and I was able to program the motes. >>>>> But suddenly I get the following error, if I try to install a >>> program >>>>> on a mote: >>>>> >>>>> >>>>> $make micaz install mib510./dev/ttyS2 >>>>> mkdir -p build/micaz >>>>> ..... >>>>> ..... >>>>> ..... >>>>> writing TOS image >>>>> cp build/micaz/main.srec build/micaz/main.srec.out >>>>> installing micaz binary using mib510 >>>>> uisp -dprog=mib510 -dserial=/dev/ttyS2 --wr_fuse_h=0xd9 >>>>> -dpart=ATmega128 --wr_fuse_e=ff --erase --upload >>>>> if=build/micaz/main.srec.out >>>>> Firmware Version: . >>>>> Failed to enter programming mode. >>>>> make: *** [program] Error 2 >>>>> >>>>> I have looked in the mailinglist, but there was no proper > solution >>> for >>>>> this problem. >>>>> Please can you help me? I have no idea how to fix this problem. >>>>> >>>>> Best regards, >>>>> Isa >>>>> _______________________________________________ >>>>> Tinyos-help mailing list >>>>> [email protected] >>>>> > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-he >>> lp >>> _______________________________________________ >>> Tinyos-help mailing list >>> [email protected] >>> > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-he > lp _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
