Pretty easy if it is an interior wall, and more challenging if it's an exterior wall because exterior walls tend to be filled with insulation. In either case it's good to know if any plumbing or electrical lines run in the space you're looking at. A 'fish tape' (http://en.wikipedia.org/wiki/Fish_tape) is a handy tool when pulling wires through walls.
Personally I hate doing plaster or drywall stuff (my wife hates it more when I do it) so I end up using surface mount jacks on the baseboard. I terminate the cable using RJ-45 jacks like these (http://www.broadbandutopia.com/levquicsnapc1.html). For a simple direct connection I use a 'surface mount housing like this' (http://images1.cableorganizer.com/leviton/surface-mounts/images/02-2-port.jpg)). I think 'flush-mounted wall plates' (http://www.vpi.us/catacc-plates.html) look better, but they involve cutting into the wall. Some people don't use any jacks, and instead have a cable with the RJ-45 plug sticking out of the wall or floor like a pigtail. Don't do that. Not only is it ugly, but using the jacks is much more flexible, as you can put the equipment anywhere you want, and then use an ethernet patch cord of the correct length to connect to the jacks. -- aubuti ------------------------------------------------------------------------ aubuti's Profile: http://forums.slimdevices.com/member.php?userid=2074 View this thread: http://forums.slimdevices.com/showthread.php?t=85420 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
