> Van: Mark <[email protected]> > Aan: "'[email protected]'" <[email protected]> > Onderwerp: Wave-shaping/Mute circuitry for Holland Pulse Dialing > Datum verzending: Wed, 19 Jun 1996 14:09:25 -0400 > Stuur antw. aan: [email protected] > > > Dear treg members, > > Until recently Holland had wave-shaping (Mute) requirements for > terminal equipment attached to the PSTN. In order for our products > to satisfy these requirements, additional circuitry was necessary.
In the Netherlands we still have the pulse dialling requirements, but if pulse dialling is disabled (no possibilities to dial with pulses and not mentioned in the user manual), it is not necessary to perform the pulse dialling test cases. > It has recently been brought to my attention that these > requirements no longer existed in Holland (because Holland is now > primarily DTMF). Since a few years, the PSTN network in the Netherlands is fully DTMF (also pulse dialling is still possible). Please note that there are always consumers who have 'home'-PABX's which can only recognize pulse dialling internally. > Additionally, what, if any, does this rule change have on > Luxembourg PSTN TE approvals? (Before this change, approval in > Luxembourg was obtainable with a Holland approval.) As far as we known, this doesn't change the Luxembourg PSTN approval. Kind regards, Mark van der Doelen Telefication b.v. ==================================================================== Mark van der Doelen Telefication bv Salesmanager tel: +31 263 780 742 e-mail: [email protected] fax: +31 263 780 789 private: [email protected] tel/fax: +31 735 324 385 ====================================================================
