Bill, As per my calculations: focal distance 553 mm, arms length 747 mm (between bendings). I sent to your private e-mail a *.xls file, a *.jpg file and a *.dwg file, because Yahoo is stripping away any image attached. Please examine, in details, the files I sent.
Loures/Maceio/Al/Brazil ----- Original Message ----- From: ocsrc1 To: [email protected] Sent: Wednesday, January 02, 2008 2:14 AM Subject: [TVRO] Re: Need help with measurement on 5 foot dish support arms If my math is correct the Focal Distance is between 21 and 22" But I'm not sure if this from the dead center of the dish or even with the outer edge. If it was dead center then the feedhorn would only be 11" above the dish edge. If it is from equal with the edge of the dish, then it would be 31" from the bottom of the center of the dish. Does anyone know which of these is true? Once I have the correct location for the feedhorn, then it form a triange with a 90 degree right angle and I should be able to find the length of the long side since I would know the 2 other sides. I know there is a formula to do this, but it's been a long time since I was school. AutoCAD would be able to plug these numbers in and find the answer in a second. If you have AutoCAD and can make a sketch, or JPG, SWF , or other type of file, please send it to my primary address [EMAIL PROTECTED] Thanks again Bill --- In [email protected], "ocsrc1" <[EMAIL PROTECTED]> wrote: > > The dish is 59" wide and 10" deep. > > Hope this helps > > Bill > > > > --- In [email protected], "Geraldo Paiva" <loures@> wrote: > > > > Considering the attachments is being stripped away by Yahoo, > please see the two dimensions I need: dia of dish and depth of dish. > > > > > > !------------------ dia of dish ------------------! > > ...................................................... ---- > > .......................!..................... > > ..................!.............. HOW DEEP IS > DISH > > ............!......... > > ....!.... ----- > > > > > > ----- Original Message ----- > > From: Richard A. Keirstead > > To: [email protected] > > Sent: Tuesday, January 01, 2008 4:36 PM > > Subject: Re: [TVRO] Re: Need help with measurement on 5 foot dish > support arms > > > > > > Yahoo Groups strips away all attachments. You will need to send > the > > sketches direct to the other person instead of via Groups. > > RAK > > > > Geraldo Paiva wrote: > > > > > I tryed three times to send the sketch. Certainly, Yahoogroups > is > > > blocking the attached sketch, I see. > > > > > > You have already furnished the distanCe between holes of > feedhorn ring > > > (5.3/4"). Ring deep 1'. OK. tHe opening of the feedhorn extends > down > > > 3/4" from the bottom of the ring. OK. > > > > > > Are missing > > > > > > DIAM > > > <------------------------------------------------------> ----- -- > > > . . ! > > > . . ! > > > . . ! DEPTH > > > . . ! > > > . . ! > > > . ------- > > > > > > Loures > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > [Non-text portions of this message have been removed] > > > [Non-text portions of this message have been removed]
