I do 1/4 turn after finger tight. I'm currently working on a similar issue that I believe is interference however it only shows on any/all of the lower frequencies. Higher freqs are fine :(
On Wed, Jun 14, 2017 at 10:53 PM, Josh Luthman <[email protected]> wrote: > I have always done finger tight because I read somewhere in ancient times > overtightening​ is really bad (not sure why). It's it generally practiced > to tighten a little bit, ie quarter turn? > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Jun 14, 2017 10:50 PM, "Clay Stewart" <[email protected]> > wrote: > >> Don't believe in coincidences.... rain.... drop side... moisture or loose >> ant nut. Latter is more common as techs sometimes forget to wrench 1/4 >> turn... finger tight will loosen. Also, many radios come with the curl nut, >> under the male antenna plug on radio, is loose and under it is a tiny >> rubber washer. So what happens is you tighten ant cable properly, but the >> under curl nut is up some micro meters, enough for moisture to get in. You >> should check every radio's curl nut with a small pliers before attaching >> ant cable. >> >> On Wed, Jun 14, 2017 at 1:10 PM, Josh Luthman < >> [email protected]> wrote: >> >>> Any guesses? >>> >>> I replaced one side and jumpers. Can't do anything in this heavy rain >>> on the other side :( >>> >>> Josh Luthman >>> Office: 937-552-2340 <(937)%20552-2340> >>> Direct: 937-552-2343 <(937)%20552-2343> >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >>> _______________________________________________ >>> Ubnt_users mailing list >>> [email protected] >>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>> >>> >> >> _______________________________________________ >> Ubnt_users mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/ubnt_users >> >> > _______________________________________________ > Ubnt_users mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/ubnt_users > > -- -RickG
_______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
