Ya, I've had a few jumpers fall apart lately too! On Thu, Jun 15, 2017 at 10:54 AM, Josh Luthman <[email protected]> wrote:
> It was a jumper. > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Jun 15, 2017 9:44 AM, "Ethan E. Dee" <[email protected]> wrote: > >> Depends. >> >> The chains are two different axes. You could get some thing close enough >> to favor only one. >> >> It's a stretch but certainly possible. >> >> On 06/15/2017 09:12 AM, Josh Luthman wrote: >> >> Correct me if I'm wrong but I don't think a reflection or path >> obstruction would effect one chain leaving the other unaffected. >> >> With all this rain all the critters are dead. >> >> >> Josh Luthman >> Office: 937-552-2340 <(937)%20552-2340> >> Direct: 937-552-2343 <(937)%20552-2343> >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> On Thu, Jun 15, 2017 at 9:10 AM, Ethan E. Dee <[email protected]> >> wrote: >> >>> Check your airview (does af5x have airview? I forget). That would be >>> some pretty nasty interference to cause that. >>> >>> Also, reflection of some kind. Is there something new in the way? >>> >>> Also, besides weather, critters can sometimes cause issues on chains as >>> well. >>> >>> On 06/15/2017 01:35 AM, RickG wrote: >>> >>> I do 1/4 turn after finger tight. I'm currently working on a similar >>> issue that I believe is interference however it only shows on any/all of >>> the lower frequencies. Higher freqs are fine :( >>> >>> On Wed, Jun 14, 2017 at 10:53 PM, Josh Luthman < >>> [email protected]> wrote: >>> >>>> I have always done finger tight because I read somewhere in ancient >>>> times overtightening​ is really bad (not sure why). It's it generally >>>> practiced to tighten a little bit, ie quarter turn? >>>> >>>> Josh Luthman >>>> Office: 937-552-2340 <%28937%29%20552-2340> >>>> Direct: 937-552-2343 <%28937%29%20552-2343> >>>> 1100 Wayne St >>>> Suite 1337 >>>> Troy, OH 45373 >>>> >>>> On Jun 14, 2017 10:50 PM, "Clay Stewart" <[email protected]> >>>> wrote: >>>> >>>>> Don't believe in coincidences.... rain.... drop side... moisture or >>>>> loose ant nut. Latter is more common as techs sometimes forget to wrench >>>>> 1/4 turn... finger tight will loosen. Also, many radios come with the curl >>>>> nut, under the male antenna plug on radio, is loose and under it is a tiny >>>>> rubber washer. So what happens is you tighten ant cable properly, but the >>>>> under curl nut is up some micro meters, enough for moisture to get in. You >>>>> should check every radio's curl nut with a small pliers before attaching >>>>> ant cable. >>>>> >>>>> On Wed, Jun 14, 2017 at 1:10 PM, Josh Luthman < >>>>> [email protected]> wrote: >>>>> >>>>>> Any guesses? >>>>>> >>>>>> I replaced one side and jumpers. Can't do anything in this heavy >>>>>> rain on the other side :( >>>>>> >>>>>> Josh Luthman >>>>>> Office: 937-552-2340 <%28937%29%20552-2340> >>>>>> Direct: 937-552-2343 <%28937%29%20552-2343> >>>>>> 1100 Wayne St >>>>>> Suite 1337 >>>>>> Troy, OH 45373 >>>>>> >>>>>> _______________________________________________ >>>>>> Ubnt_users mailing list >>>>>> [email protected] >>>>>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>>>>> >>>>>> >>>>> >>>>> _______________________________________________ >>>>> Ubnt_users mailing list >>>>> [email protected] >>>>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>>>> >>>>> >>>> _______________________________________________ >>>> Ubnt_users mailing list >>>> [email protected] >>>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>>> >>>> >>> >>> >>> -- >>> -RickG >>> >>> >>> _______________________________________________ >>> Ubnt_users mailing >>> [email protected]http://lists.wispa.org/mailman/listinfo/ubnt_users >>> >>> >>> >>> _______________________________________________ >>> Ubnt_users mailing list >>> [email protected] >>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>> >>> >> >> >> _______________________________________________ >> Ubnt_users mailing >> [email protected]http://lists.wispa.org/mailman/listinfo/ubnt_users >> >> >> > _______________________________________________ > Ubnt_users mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/ubnt_users > > -- -RickG
_______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
