That is a perfect result: all 26 tables loaded, routing bit 1, 0 IRQs while idle and no duplicate objects. Thanks for testing on F.10, it confirms the bug and the fix on a second BIOS version and digitizer revision (43EF).
The dracut-rescue error is not from the fix. That script only refreshes the rescue boot entry, and your system has no rescue entry file (...-0-rescue.conf), so it fails. The fix only adds an ACPI table setting to dracut and does not touch rescue entries; your normal kernel was installed fine. The directory you created by hand is harmless; you can remove it if that old 7.3.0-rc0 kernel is no longer installed. Two things: 1. After you reboot into the new 7.2.8-200 kernel, please run "sudo hp-touch-irq-fix verify" once more. It should still say PASS, which confirms the fix carries over to new kernels automatically. 2. Before updating the BIOS to F.20, run "sudo hp-touch-irq-fix uninstall". After the update, reboot once, then run "install" again. (If you forget, it removes itself automatically after detecting the new BIOS.) Much appreciated! -- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/2142384 Title: ELAN2514:00 (04F3:4428) stylus report rate extremely low (~10–25 Hz) on Ubuntu 24.04 kernel 6.17 To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/linux/+bug/2142384/+subscriptions -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
