If your pump has its own panel breaker RATED for your pump, you should be all set. Your pump should be on a separate breaker. The fuse holder you have is defective so do not use it and toss it out. If you want to add another fuse holder right after the pump, it will not hurt. Capt. Perry
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Bob S Sent: Tuesday, August 11, 2009 8:29 PM To: UnifliteWorld Subject: [UnifliteWorld] Fuse question I installed a new freshwater pump and it came with an automotive type fuse holder (square fuse with 2 prongs) Anyway the fuse does not make adequate contact and cuts out until it's wiggled. I have given up on the set up. My question is. do I need an in line fuse when it is wired thru the dc panel with a separate breaker. If I can hard wire it in I will, otherwise I will get a traditional fuse holder to replace it. Thanks. --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "UnifliteWorld" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/UnifliteWorld?hl=en -~----------~----~----~----~------~----~------~--~---
